Rear hub stud compatibility.

[johnymd]

Any links Ben? I can’t see for looking, although I am specifically looking for longer ones.

 

[Paul_S]

I really struggled to find longer studs. The replacements were either the wrong thread, or had the wrong diameter spline. I scoured the web and when I found what appeared to be the correct item, the website was wrong and the ones shipped were not the same dimensions as stated.

In the end, I resorted to drilling out the holes and fitting bigger diameter splines because I needed to keep the same wheel nuts.

 

[moggy240]

Got a part number for mine
40222-RS020
13mm knurl 60mm studs x8

 

[toopy]

These are the ones i bought https://www.ebay.co.uk/itm/8-x-Knoc...-x-1-5mm-13-1mm-Spline-47mm-Long/312021589902

Had them fitted by a local machine shop, so i don't know if the hub holes needed a little reaming!

 

[ben240z]

.

I stand corrected, I use 12mm by 1.5 pitch by 68mm long. They are escort long studs

 

[Fastededdie]

I am sure that the pitch is 1.25 but does it matter?

 

[toopy]

I am sure that the pitch is 1.25 but does it matter?

Yes 1.25 for oem studs, not easy to source in the length i wanted, so i used some 1.5 ones and bought another set of wheel nuts. I only needed to change the fronts so the rears are still 1.25!

1.25 pitch is a slightly finer thread, which means there will be slightly more thread engaged in the wheel nut, but it's minimal, so for most applications probably irrelevant.