SdR
Club Member
So FOR SALE, low mileage road use and few track days engine and box.
Spec 2 RB25DET
87mm Wiseco pistons
Calic bearings
GTR conrods
Cosworth 1.5mm head gasket
ARP head studs
Rebuild cylinder head with relapsed valves
Oil pump
HKS Kevlar can belt and tensioner kit
Water pump
555 injectors
Drift stainless manifold
Greedy plenum
Q45 throttle body
Z32 ecu
Z32 afm
New Apexi Air filter
Chinese gt3076 turbo
Super fly flywheel (used only a few times)
ACT extreme clutch (again only used a few times)
RB20det gearbox
Engine and box mounts (for s13 swap)
The chap that had the long block before me that had it on the road was using a genuine gt3076r making 477bhp @ 1.4bar.
I used it on stock power for comp until i planned on getting a fancy ecu, however, i no longer need it.
Had all new belts too, has had a service, fluid change after the track days I've done. I have also replaced the cold/hot sensor.
Link with Vid: https://www.facebook.com/Smokin-Customs-1376954885958654/?pnref=story
Located Near Odiham RG29.
£2695.00. ovno
Spec 2 RB25DET
87mm Wiseco pistons
Calic bearings
GTR conrods
Cosworth 1.5mm head gasket
ARP head studs
Rebuild cylinder head with relapsed valves
Oil pump
HKS Kevlar can belt and tensioner kit
Water pump
555 injectors
Drift stainless manifold
Greedy plenum
Q45 throttle body
Z32 ecu
Z32 afm
New Apexi Air filter
Chinese gt3076 turbo
Super fly flywheel (used only a few times)
ACT extreme clutch (again only used a few times)
RB20det gearbox
Engine and box mounts (for s13 swap)
The chap that had the long block before me that had it on the road was using a genuine gt3076r making 477bhp @ 1.4bar.
I used it on stock power for comp until i planned on getting a fancy ecu, however, i no longer need it.
Had all new belts too, has had a service, fluid change after the track days I've done. I have also replaced the cold/hot sensor.
Link with Vid: https://www.facebook.com/Smokin-Customs-1376954885958654/?pnref=story
Located Near Odiham RG29.
£2695.00. ovno
