bluejon
Club Member
Does anybody know or have a pic of what goes into the hole in the centre of this picture. It is the rear of the heater panel - the dark coloured arm is that of the top slider control to select HEAT v VENT, and the two brassy plates sitting above it slide relative to each other as the control arm swings left or right.
But to do this all three should be pinned through in some way. The hole in the selector arm is not threaded, so some kind of bar or rod? Not being threaded I'm not sure how it would stay in situ, but nor, if fixed firmly to the selector arm how it is missing unless removed in the past
But to do this all three should be pinned through in some way. The hole in the selector arm is not threaded, so some kind of bar or rod? Not being threaded I'm not sure how it would stay in situ, but nor, if fixed firmly to the selector arm how it is missing unless removed in the past
Last edited by a moderator: