Coolant Temp Sensor Thread Size? | The Z Club of Great Britain
  1. The Z Club relies on the support of it's paid members - join the club or renew your membership here.

Coolant Temp Sensor Thread Size?

Discussion in 'General' started by strugrat, Nov 13, 2018.

  1. strugrat

    strugrat
    Z Club Member

    Hello all,

    As per the title does anyone know the thread size on the coolant temp sensor?

    Trying to fit the Autometer sender unit (1/8th NPT) into the hole, none of the adapters provided fit. I assume the coolant housing is also NPT thread?

    Appreciation in advance
    Ryan
     
  2. johnymd

    johnymd
    Z Club Member

    12x1mm I think.
     
  3. strugrat

    strugrat
    Z Club Member

    Thanks Johnny, I'll try that.
     
  4. moggy240

    moggy240 INSURANCE VALUATIONS OFFICER Staff Member Moderator

    I am not sure but I fitted the auto meter temp sender but I can't remember how I did it but will have a look tonight and let you know.
     
  5. IbanezDan51

    IbanezDan51
    Z Club Member

    It’s definitely metric. Either 10mm or 12mm and fine thread.
     
  6. strugrat

    strugrat
    Z Club Member

    Nice thanks. It looks waaay bigger than that.
     
  7. moggy240

    moggy240 INSURANCE VALUATIONS OFFICER Staff Member Moderator

    I fitted mine to the water pipe side to match one of the adapters but I think it had been tapped out much bigger that what should have been there. [​IMG]

    Sent from my WAS-LX1A using Tapatalk
     
  8. strugrat

    strugrat
    Z Club Member

    Thanks all, I found something on a forum in the states that says its M16 x 1.5. Vernier's indicate this could be right.
     

Share This Page