Just started strip down Datsun 240, the cable lugs holding cable runs in place are rusty and some are snapping off
Any Advice please for the refurb - do I cut them all off and use something else or replace.
Is there a replacement part to use / weld back on.
New weld on wiring holders for Datsun 240Z, 260Z, 280Z and 510. These steel tabs are modeled after the originals with a larger hole at the base for a plug weld. A 240Z uses approximately 80 of these tabs throughout the car. The most popular size used is the "Short" tab at 65mm. The "long"...