To change mine I used very hot tap water (I also washed the years of dirt off inside and out whilst at it)
This made it really easy to take off the lens.
I then used a sturdy flat blade screwdriver whilst it was still hot to get out the excess left in the fitting.
I used white tiger grip to...
Hi, assuming you mean indicators ?
The lens would still show a red indicator even with the orange bulb, potentially not enough of a colour change.
I found these:
https://klearz.com/products/datsun/280z/280z_lower_tails
Hope it helps 🙂
I didnt think the thickness would stop the intake, so I havent allowed for that.
Was it the physical pipe to intake? Or the fixing points at the gasket?
I'll be checking on Sunday, will report back 👍🏼
I used Pitking, only based on reviews though.
I found it a good thickness and flexibility to allow the tight corners to be a little easier to not have saggy bits.
From my recent experience I wouldn't want to do it attached to the block. I used a lot of swears as it was on a carpet in the...
Finished wrapping the Z story header,
I was looking at ceramic coating, with delays I really want to run the car from April time.
Also whilst it looks tidy, I think the wrapping will give a better heat reduction in the engine bay.
I did mine over 2 days
Post in thread 'Here we go.... 76 280z rebuild/restomod' https://zclub.net/community/index.php?threads/here-we-go-76-280z-rebuild-restomod.28396/post-335514
They look awesome! Some lovely new additions for yours!.
Is that a vacuum pump I can see in the wheel arch? I am in two minds as to whether I need one.. can i ask what made you decide on one and does it solely drive vacuum to brake and heater controls.. thanks
When I had my cam made they suggested the lifters should be changed/re worked. I am not an engine guru but they wouldnt do the cam without it and only £12 each so certainly didnt do it for revenue..