Search results

Sometimes if some ones not complaining there is something wrong

Almost done

How is the "W" bolt situated on send port? 1988 300zx. Power steering pump

That is the simple truth my friend. I can pretty much figure all that out on own. Dont need an online community to put 2 & 2 together .

My power steering pump rebuild is leaking at the threading the supply line bolt into. I replaced the o ring. It leaks as i was filling resevoir with out the pump running. Its torqued to specs. The port lines up in the supply line bolt threads. The image below is the leak site. If I tighten bolt...

That didn't help me with my issue. The dude said he had a machine shop do it. I can deduce that remedy with my logic.

That did not help. Thanks. Please Refer to the image. Im interested in removing,disassembling ,pulling the shaft from the housing, to replace the seal. The front side. Pully side.

1988 300zx z31 base.

Can some one please guide me on removing the pulley shaft from the power steering housing?