I’m in North London and work near St Albans so as long as I’ve sorted out my brake issues It would be good to meet up I know of a few Z’ds around...
If the other guy does not collect them than you can have them.
The rods on the pedal/servo have adjusted/ checked by FourWays. So I’m sure that’s ok plus there was a change in the heat build up on the wheels....
Front pipes have been replaced 6months ago. The rear ones where replaced about 4 years ago by the last owner
All yours chap.
The brake pedal feels the same all the time, it does not change when the brake lock on. I’ll have to check the vacuum next time I’m out with it.
I’ve got four 280zx wheels taken off my 280z.
They can be collected from North London as there to expensive to post.They are in average condition...
All wheels seem locked on even with the handbrake off. Just thought now you mentioned it the engine drops from it’s idle to about 500rpm and...
Hi all I’m looking for some help/advice.
I’ve got a 76 280z, after about a half hours drive which is around 8 to 10 miles the brakes on the car...
Did I see cross flow head on the orange car?
How many confirmed orders would be needed to make it worth doing ?
I’m sure there is enough talented people on here to make it work.
Hi Sean .
Will you be producing a twin exit (Horizantal) pipe as I remember seeing it mentioned on you website?
Here’s a photo of them. Was surprised by the quality considering the very reasonable price.
At the moment it’s a stock car apart from Toyota front calipers and its got a set of poly bushes.
I got zero offset on the wheels after talking to...
I see you point about the Falkens the thought had crossed my mind too. I don’t fancy Toyo tyres as there too track based, worked well in my GTiR...
I’ll unbox them later this weekend , not had any time to yet
I had a delivery this week as I actually found a real Black Friday deal from JBW and not made up deal that’s becoming common.
There 7x15 and was...
It sits about 20mm out when pushed back in to its housing. While I was trying loosen of the lock nut ive groved the shaft so I think I need a new...
Can you tell the thickness of the plate in the picture.
I’ve got the Toyota four pots sitting in my garage, need to get it done soon myself.
Separate names with a comma.