Anyone had any replies from Adz on this?
That's a pretty elaborate crank sensor mount - is that something you got machined up yourself?
Perfect, thank you!
Been searching around on the internet to no avail and I don't have my car nearby to check myself - could anyone give me the thread size for the...
Nearside front wing in good condition, £250 collected from Kent
Just checked mine and you're right, mine is quite a bit different:
Perfect, thank you!
Thanks for that!
I think yours might be different - I’ll check the bent bumper I have tomorrow and have a look.
Is someone here able to get me the distance between the two inside studs on a 240Z bumper please?
I.e. this measurement:
Fibreglass dashboard taken out of my 240Z.
Has some marks, but generally pretty good condition.
Has mounting holes to bolt to the steel dash...
Seen some cars with this, some without - any particular advantage?
Been meaning to do this on mine for a while now, glad to hear it’s fairly simple and actually makes a difference!
Good point - The fronts are 15 x 9 ET-13 and the rears are 15 x 10 ET-19.
I am planning on trying to find some good arch repair panels!
Here's what 15 x 9's on the front (225/50R15 Advan A048 tyres) and 15 x 10's (235/50R15 Toyo R888 tyres) on the rear look like with the Marugen...
"Most of the sockets in the back of the instruments are a...
I've watched all of them so far and trust me, it gets more and more impressive...
Okay these replies are very helpful, I thought I was going mad for a bit there.
The comparison between the MSA header and seans is pretty eye...
I've got a MSA 6 into 2 exhaust manifold and after fitting it I've noticed the downpipe drops down very low under the car (it could sit a...
I've got a set of Ground Control coilovers on the Z that came with the car and I'm going about setting them up at the moment.
Bought this starter motor from RockAuto a while back but ended up not using it:...
Thanks Mike, my bumper does not have these mounts, it's mostly likely a repro. It shouldn't be too difficult to fab up some brackets now I know...
Separate names with a comma.