Ok, no hurry. I can model the parts if needed. Just let me know.
Thanks for that. I think it was the lid that was requested but I can work with that too if required.
The quality of the prints off the bed is pretty good. Much better than the cheap consumer level 3D printers. A lot of people are making end use...
I can print one no problem. I'll need dimensions though or a broken one to go from and create the model. Otherwise its just guess work.
Sent you a PM
Just the models will be fine if Robbie is prepared to model them. If you can export an STL file from the CAD software then I can do the rest,...
Yes I do have access to a very good 3D printer (and 3D scanner soon for accurate parts recreations) for my business. Its industrial hardware...
Depending on size I could get them 3D printed. I'd need dimensions to create the model.
Would be printing in Carbon Composite too, Nylon with...
Was filmed about 30 minutes east of Cambridge Rob. Near Sudbury.
Cheers all for the comments.
Thanks Sean. Was going to post but hadn't got around to it yet!
Should be ok for this.
Yes BC Coilovers for height and full TTT suspension/steering arms for the geo.
I forget exactly but it was around 600 for the setup. Was a whole days labour on the ramp (8-9hrs)
Cant recommend them enough. Transformed the car tbh.
1080Kg with pretty much a full tank of fuel.
Weighed at Center Gravity in Atherstone during full alignment and corner weighting.
All the best Mark. See you when you get back.:thumbs:
I cant recall exactly, was quite pricey for me as I imported basically an entire front end. You can add the parts to basket and then they'll...
I needed RH and LH quarter panels (plus loads of others) and ended up importing used panels from Z Car Source based in Arizona. The panels were...
Separate names with a comma.