Matt Berry
Club Member
Today I set about stripping apart all the suspension and drivetrain.
Being it’s a 280z I assume it’s a R200 diff but can’t see any markings on it to indicate this.
Whilst taking apart all the mountings and giving them a going over with a wire wheel I came across a bracket that doesn’t look standard, more home made and I can’t figure out what it was actually doing.
I’ve attached a picture of the mount with the bracket attached and then when it was taken apart and cleaned, also attached a picture of the diff to see if anyone can tell by looking at it. It does have “392” stamped on the top, guessing that’s the ratio?
Being it’s a 280z I assume it’s a R200 diff but can’t see any markings on it to indicate this.
Whilst taking apart all the mountings and giving them a going over with a wire wheel I came across a bracket that doesn’t look standard, more home made and I can’t figure out what it was actually doing.
I’ve attached a picture of the mount with the bracket attached and then when it was taken apart and cleaned, also attached a picture of the diff to see if anyone can tell by looking at it. It does have “392” stamped on the top, guessing that’s the ratio?
Attachments
-
21F23FB5-53B2-497A-9D58-902DECF3EFD5.jpeg459.6 KB · Views: 53
-
A4374B13-51F5-49C6-96C0-EC3A1AD881E0.jpeg215.6 KB · Views: 53
-
DB65DEAB-0F72-44E5-A0B0-7BAE8C393717.jpeg168.6 KB · Views: 54
-
996D2B85-1F95-412D-9A49-CEE8787780B0.jpeg394.4 KB · Views: 51
-
3E6583A2-9F2D-4CAE-8F2C-A195293649A1.jpeg256.4 KB · Views: 51