Recent content by Tariq.Malik

  1. Tariq.Malik

    Datsun 280zx

    Hello Steve, I have tried but I have experienced an error with PMing you. Could you kindly message me? Thanks Tariq
  2. Tariq.Malik

    Datsun 280zx

    Hello Steve I am interested in the panels. How do I PM you on here? Regards Tariq
  3. Tariq.Malik

    Datsun 280zx

    Good evening, I have finally started work on the rebuild the 280zx that I bought 2 years ago. However I have foubnd I need panels for the car and Iam hoping that someone can advise me as to where I could buy replacement front wing quarter panels. Actually where is the best place for 280zx...
  4. Tariq.Malik

    280zx

    Morning, thanks for that advice. I was dreading researching where to find all the different sizes of hose that I will need. Having seen the state of a couple of the fuel lines I think it would safe of me to replace all the hoses rather than be selective. I decided to start from back to front...
  5. Tariq.Malik

    280zx

    Thank you Huw, I had not realised that so e form of mastic is used. I will follow your advice. Tariq
  6. Tariq.Malik

    280zx

    Slowly striping the car and fnding a few issues. Expected some rust, so that was. What is did not expect was the rear window seal to be held in with what seems to mastic. Is that usual? Where would I find a new seal? Thank you.
  7. Tariq.Malik

    280zx

    Also, any advice That looks a lot better then mine. I had mine shipped from South Africa, as I could not find any in the UK. As soon as I paid up, arranged shipping, I found one on eBay for £5k, almost the same cost as mine with all the shipping, HMRC duty etc.
  8. Tariq.Malik

    280zx

    Thanks Huw.
  9. Tariq.Malik

    280zx

    I completely agree had this been a 240 or 260 I would not have considered changes of that level.
  10. Tariq.Malik

    280zx

    A fuel injection L28 engine, hoses need replacing. I have it booked into a friend's garage for a pre MOT check to give me an idea as to what is needed to make it road worthy before I look at the aesthetics and possible engine rebuild.
  11. Tariq.Malik

    280zx

    thank you, any help would be gratefully received.
  12. Tariq.Malik

    Comment by 'Tariq.Malik' in media 'IMG_1874'

    @woody Hello how are you? I am looking for help with the car I have. I am not sure how to add a picture to this message but I think the front end needs some work, perhaps even replacing but I need some who has a better understanding of the support member than I do. Tariq.malik49gmail.com
  13. Tariq.Malik

    280zx

    In the words of Ness "tidy". The hoses are old and need replacing, the fuel hose had split gushing fuel, so I have ordered hoses. Trying to work out what sizes I need so I can replace them all. It drives a bit sluggishly, over 284k on the clock so I think an engine is due. Upgrade the exhaust...
  14. Tariq.Malik

    280zx

    Good evening, My first post by way of introduction and a request for help with advice. I am Tariq a mature chap, not looking to recreate my youth but looking to this car as a project. My first car was a C110, the 240K GT. I have bought myself a RHD 280zx, shipped in from Cape Town. I am hoping...
Top