Recent content by M-j-b

Thank you 👍🏼really appreciate it

Lots of progress..

To change mine I used very hot tap water (I also washed the years of dirt off inside and out whilst at it) This made it really easy to take off the lens. I then used a sturdy flat blade screwdriver whilst it was still hot to get out the excess left in the fitting. I used white tiger grip to...

Hi, assuming you mean indicators ? The lens would still show a red indicator even with the orange bulb, potentially not enough of a colour change. I found these: https://klearz.com/products/datsun/280z/280z_lower_tails Hope it helps 🙂

Just starting to test fit all the front end, testing the new grille.

If you're looking for a good courier, give me a shout (I know a reliable one)

Looking awesome !! Exciting times are you sleeping ? As I didnt 🤣

I have one available if you're still looking... 👍🏼

All fitted...

Looks like the same rad I bought, quality seems good for the money 👍🏼

I didnt think the thickness would stop the intake, so I havent allowed for that. Was it the physical pipe to intake? Or the fixing points at the gasket? I'll be checking on Sunday, will report back 👍🏼

I used Pitking, only based on reviews though. I found it a good thickness and flexibility to allow the tight corners to be a little easier to not have saggy bits. From my recent experience I wouldn't want to do it attached to the block. I used a lot of swears as it was on a carpet in the...

Finished wrapping the Z story header, I was looking at ceramic coating, with delays I really want to run the car from April time. Also whilst it looks tidy, I think the wrapping will give a better heat reduction in the engine bay.

I have air con parts if you're still looking 👍🏼 I took out all my air con from the 76 280z

Arrived today! Thanks Sean