Kieronpollock

Finally made our Fairlady based house name! My wife wouldn’t let me call our new place ‘Fairlady House’, so I went with ‘Fairview’...

Problem now solved!. Master cylinder rod wasn't adjusted far enough out. With more throw, the clutch now operates nicely. Thank you all...

And would such a conversion not be considered a ‘substantial change’ for MOT purposes and therefore the car would no longer be exempt?

Same goes for cars with a modern engine change and still having their car registered as an historical vehicle.

a few days of flurry. Stripped my dashes apart, one now goes in the bin Loom removed and cleaned up ready for testing(dash loom)...

Excellent job! I found a hair dryer and the rollers used to put down the sound deadening are up great tools to have on hand to get the...

Also finally commited to glueing some vinyl down today! But I did realise I shouldn't glue the whole trans tunnel trim down yet as...

Fitted the gear shift bracket thing just for the satisfaction of it! Used the old screws for now but at some point I'll be getting a big...

Thanks everyone for your new year advice and suggestions!

Thanks Phil much appreciated and another excuse for a cup of coffee and a biccie😉

I just use the standard jack I've had for ages and run the car up onto 2 bits of wood under the wheels first, lifts the car about three...

Happy New a year everyone! First advice request of 2023. My current jack that I’ve had for years is a basic Halfords 2ton jack and has...

Yes well said, I’ve always found everyone without exception both helpful and friendly during last 18months. I’ll leave you with a photo...

This is the same place near Oxford that is selling the ‘genuine RHD imported from Japan’ car that actually is a LHD car that has created...

Agreed Rob, The only thing is it's completely hit and miss with what you are going to end up with. That 280z I had looked amazing from...