Faster Behr

That's great, thanks for your input. I will check all of that out.

I have done this with one of the rebuild kits from the states. The rebuild itself is easy. The hardest part was getting the servo open...

Drove it hard on a Track for the first time . Faultless

The brake servo on our 1974 Fairlady Z has failed. When the pedal is depressed there is a sudden inrush of air causing an engine idle...

Do you know which one this is Dan? I can’t make out the hanger lugs on the back end. Single or dual?

Hey congratulations on this, and let the fun begin huh? I'm glad to see you're getting to grips with the EFI. You definitely did the...

I think I have a set of black mesh 15's - will check :)

One of the photos near the end shows that the bonnet has been cut and welded on the centre inner; likely to try to relieve the damage...

It's definitely got a 60's Mustang vibe going on for sure!

Really you'd want to see it and confirm it selects all gears and turns smoothly.

I love the edge trim, the carpet I got from z source in USA had sewn edging but looked tatty quick, each to their own, some people have...

Early morning and long trip (left at 4.20am, 160 mile drive each way) but a fun day. Apart from the fuel cost which was depressing tbh...

Good turn out today, nice to see some new Zeds as well today. Apologies I could only stay until mid day. (Hope you got home ok Martin 😋...

I’m really cheesed off that I couldn’t make it today but it sounds like everyone had a good time. Sam got there with our Fairlady and...

Yes, we had a set originally destined for the 280Z and I refused to fit them. In fact we still have them somewhere. There are good...