Recent content by Coyd

Thanks that’s a real help

Ok thanks for your help

I have a 280zx distributor I had to remove the ignition module on the side of the distributor and wire it directly from coil when I fitted the injection system. It runs an ignition amplifier now.

Hs6 carbs yes the jets are left in. No problem not blocking off fuel inlet, as it’s only the throat of su that is used. You need to utilise all the sensors.

I’m having difficulty getting my tach to work. I recently fitted fuel injection, I had it wired into coil before and it worked fine. They say to wire tach into negative as a feed, and not to use + outlet. I’ve tried wiring other wire to a alternate + but no go. Any ideas?

I’ve used the adapter plate between carb and manifold as an injector mounting. The carbs have the pistons removed, so they act as throttle bodies. The ecu is small, everyone I’ve spoken to rates it highly. It’s fully programmable, the back up is very good, they always respond. For the money as a...

I’m running a classic fuel injection system, they use a Maax ecu. I’ve used my Su’s as throttle bodies. £1700 whole kit, everything you need.

Ok thanks.

Yes Jon unfortunately but I think I might of mistakenly set the rockers initially on hot lash instead of cold. I’ve sent cam back for re-grind It picked up on inlet third cylinder. When I put it back together I’m going to spin her over with out rockers and rocker cover off, to make sure I’ve got...

New built engine, spotless cleaned. Ran engine without cam cover to see oil flow from spray bar as its worn one cam lobe. Do you guys have a drilled cam and Spray bar?

I recently bought a drilled Newman cam, my engine has an oil spray bar. I’ve had problems of not getting enough oil on cam lobes. Question is by having spray bar and oil feed to cam will it not be building enough pressure for the spray bar to work correctly?

Thanks that’s great I have a full set now😂😂😂

What engine oil is everyone using? there’s so many conflicting opinions. Just doing 500 ml oil change after rebuild.

No a thanks for your help, I’ve sourced one now. I like the sound of the Bibury meeting, although i won’t be able to make it. Thanks again Kind regards Peter