Recent content by arcdef

Yes you can but depending on how low you run the car, it may bottom out on very high speed bumps. I have one in the centre of my car and fits fine.

Where abouts are you?

No doubting his fabrication skills, some.of the panels that have been made are impressive however the methodology of do it bit by bit rather than large sections doesn't seem the most logical. Still an interesting watch!

Hi, can I grab these please? Thanks Ash

i take mine to the local tip and they tell me to put it with the used engine oil. Only allowed a couple of containers at a time though.

Booked.

minimum order of 10 so will need to be a group buy. I saw $400 per bonnet but assume shipping will not be cheap!

https://www.alibaba.com/product-detail/High-quality-car-hood-bonnet-fender_1600958872496.html?spm=a2700.galleryofferlist.normal_offer.d_image.190362c3WeLE7A Who is brave enough? The photos look similar to parts from US/UK vendors. Id be tempted to go into a group buy on some panels.

Honestly not sure, just saw that they advertise them.

DS Composites are UK based & have started making replica parts, not sure if they sell a full set or not. https://www.facebook.com/DSCompositesUK/

Looks like reserve wasn't met at £14k

It is remarkably cheap. I was sceptical but it's been over 2 years and still working fine!

Just to put it out there but similar to others I rarely use the radio unless cruising on the motorway and refused to spend big money on one of these so thought I'd try this at £13. Honestly been very impressed, looks retro enough, sounds good enough and Bluetooth works flawlessly. Worth...

I am running front and rear control arms from Apex. They also missed some bolts on one of the orders but were quick to send replacements out at no cost (obviously) and I avoided any additional VAT charges as they marked value at $5. They do seem to be a small team and often get swamped with...

I've run mine on 30psi last few years and the wear is even across the width of the tread