AgingGeek

Im going to raise the rear up 15 mm though as the inner arch is still there... I think that the roads in the Netherlands might be...

I fixed it in the end, I think the adjusters hadn't been moved in quite some time, so just got some grips on them and they loosened up...

I think I need to adjust damping, the ride height is fine, I just need to make them stiffen quicker so they don't bottom out?

Hi all, so on my first proper drive of the 280z, its bottoming out on the rear arches and has gauged the tyres... joy. I went to adjust...

Just checked out the Raybrigs - they look nice and OE. But they're still halogen right? So would they be that much better than the old...

The headlamp buckets have a standard three screw layout. I think most 7” still will fit. Halogens are a great upgrade over sealed beam...

These are the Raybrigs fitted in the buckets with the new gaskets. Might give you an idea on how they mount.

Don’t think that’s quite right. I think you need all that stuff for HID coversions. But I believe you can get away with LED bulbs...

That is really badly worded 'Should a vehicle be presented for an MOT test with conversions before 1 April 1986 they must not be failed...

Ahh ok that's good then. Excuse me ignorance, I wasn't even aware of what a sealed beam light was until now! Didn't realise there was...

All mentioned before and Rob is right,I have the best of both worlds as I got into wot people call modern day classics ie my two...

LED's are fine except you shouldn't put H4 LED's in a reflector case. It makes the lights brighter, but they're less concentrated. You...

Yeah that makes sense. Same with Xenons - have to go in a proper projector for the job. ahh I've seen the Jeep ones mentioned. Will...

I'm sure you'll find time to enjoy both! 600bhp though, blimey. It's similar for me - I have an '05 e46 M3, which only gets used in the...

Thanks Rob, all these are very valid points. It wasn't a cheap purchase, that's for sure and I do want to protect my investment for...