Recent content by 77260

  1. 7

    Wilwood front brakes

    For me the wipe pattern was spot on and the only time the rotors cracked was when I let them get below the recommended min thickness of 20.5mm I let them get down to 18.5 when I noticed the cracks.I was way more vigilant after that! I raced the butt off the car,so the set up was definitely...
  2. 7

    Need assurance

    If you go with 8" wide ,with 0 offset you will need to roll your wheel arches.7" works with 0 offset.With 8",ideally you want +12.I'm running Rota RB's 16X8 with +10 offset on a lowered car and had to have the lips rolled more than once to stop any contact.No problem if you"re into flaring your...
  3. 7

    Wilwood front brakes

    There is no spacer required for disc to hub.You will need to drill one additional hole for the stock 4 stud pattern.I think we fitted longer wheel studs too ,to allow for the thicker rotor.Pads are available here in NZ ,not sure about UK..Here are a couple of part no's :FPR 501 R ,compound is...
  4. 7

    Wilwood front brakes

    I am using 280x22mm vented rotors off early 635/735i bimmer.,with Wilwood Superlite 4 pot callipers.These have been brilliant on road and track.I upgraded the M.C.to the 280zx 15/16" one to compensate.These calipers fit directly to the strut - you just need a 2mm washer to centre them over the...
Top