nickknox
Well-Known Forum User
I’ve changed my inlet/outlet gasket and just need a bit of advice on mounting the Weber’s back to the inlet manifolds.
I’m going to change the Marib rings and the bobbins and caps. Where the best place to get these from?
I understand the carbs should be tightened so there is a 1 mm gap between the caps encasing the rubber bobbins. Is this correct?
When I took the carbs off there was a washer also between the caps so it went cap/washer/bobbin/cap. This looks to me as if someone put it together wrong at sometime. Also the caps were almost touching. I’m guessing this had the effect of the carbs being to tight to the engine causing vibration.
Thanks in advance for any advice
I’m going to change the Marib rings and the bobbins and caps. Where the best place to get these from?
I understand the carbs should be tightened so there is a 1 mm gap between the caps encasing the rubber bobbins. Is this correct?
When I took the carbs off there was a washer also between the caps so it went cap/washer/bobbin/cap. This looks to me as if someone put it together wrong at sometime. Also the caps were almost touching. I’m guessing this had the effect of the carbs being to tight to the engine causing vibration.
Thanks in advance for any advice