Rear ARB Bracket

yellowz

Club Member
I have these brackets on the rear crossmember and I think they are for the anti roll bar. They seem to take a square roll bar bush.

My question is this, is there a specific metal tab that closes the bush in and clamps up? There is a hole in the down facing piece which accepts a tongue of a bracket and a captive nut above the circular hole.

if there is a bracket where can I get two, or will it be easy for someone to fabricate?

Thanks
 

Attachments

  • 20180610_110114.jpg
    20180610_110114.jpg
    122.5 KB · Views: 23
  • 20180610_110134.jpg
    20180610_110134.jpg
    150.9 KB · Views: 23

jonbills

Membership Secretary
Site Administrator
You are right, they’re the brackets for the rear ARB. You’re missing a mainly flat retainer with a bent tab that goes through the slot and a hole at the other end for the bolt to go through. Very easy to make I’m sure.
 

moggy240

Insurance Valuations Officer
Staff member
Club Member
I have had a look and I can't find any, the only ones I have came with a k-mac anti roll bar but they are not the right shape.
 
Top