RB 240z Conversion

[datsun dave]

Its running again BUT it wont idle very well,

Injectors are now out beening flow tested if they are OK its down to a AFM.

 

[johnymd]

So what was stopping it running?

 

[datsun dave]

So what was stopping it running?

Sorted out the fuel map (over fueling) and a brand new set of plugs and it started

Happy man today.

 

[Rob Gaskin]

Good news, in fact brilliant news. I'm going to the pub tonight to celebrate - any excuse

John, you were on the right track about a too rich mixture then

 

[STEVE BURNS]

Sorted out the fuel map (over fueling) and a brand new set of plugs and it started

Happy man today.

So So pleased for you
If it had been me I would have been doing a Basil Fawlty on it

 

[candy red]

Well done Dave ,now to have some fun

 

[Ian]

Great News, not long until you have her out running properly on the roads now.

 

[richiep]

Great news Dave! After all the faff, finally some results! You still MOTing tomorrow? I'm assuming you are erring on the side of caution and not planning to run it to Japfest?

Plus it means I did the right thing putting you down for Tatton in June!

 

[Wyn]

Well done. Bet you're buzzing now to try it out

 

[Rob Gaskin]

Great news Dave! After all the faff, finally some results! You still MOTing tomorrow? I'm assuming you are erring on the side of caution and not planning to run it to Japfest?

Come on, this car needs to go to Japfest!

 

[datsun dave]

Come on, this car needs to go to Japfest!

Just no time left the injectors have been taken out to be flow tested I have no MOT so no RFL i also need to get the car on a rolling road up at Warrington when the injectors are back.

 

[richiep]

Are you a passenger with me then? Early start Saturday - leaving mine at 4... :O

 

[datsun dave]

Are you a passenger with me then? Early start Saturday - leaving mine at 4... :O

I will give you a call tomorrow.

 

[richiep]

Okay, cool.

 

[Mr.G]

Well done Dave! Good to hear all sorted now

 

[Ian Patmore]

Yes, well done, worth the frustration in the end.

 

[Ian]

Any more progress?



Do you know the inner diameter of your watanabes? I need to check it to work out brake clearance on the rear brake setup I'm looking at.

 

[datsun dave]

Any more progress?



Do you know the inner diameter of your watanabes? I need to check it to work out brake clearance on the rear brake setup I'm looking at.

Yes waiting for a slot at the rolling road I can measure the wheels over the weekend for you.

 

[richiep]

It's running and drivable then on a basic map? Is it going to debut this weekend at Tatton? Please say yes!

 

[Ian]

Yes waiting for a slot at the rolling road I can measure the wheels over the weekend for you.

Not long now then?


That would be great if you could get me the measurements, thanks.