Advice needed on rear end build..

Sean287

Well-Known Forum User
Thanks Johny,

First thing to get is an R200 in the desired ratio and 260 output stubs. Do my existing half shafts fit the 260Z stub axles? I keep reading about 25 spline and 27 spline stub axles?
 

Ian

Club Member
At 300hp I feel your at the point where you could keep a lot of you existing stuff as long as it in good condition but moving to an LSD is a must or you won't be able to make the most of the cars potential. Moving to cv's is a whole load of expense and hassle that I don't think you need and I'm not sure they are any stronger.
The 280ZXT cv shafts might not be much stronger, but the Z31T cv shafts definitly are, especially once you have changed to the stronger, thicker custom shafts that are required to make this setup work properly due to the original Z31T shafts being slightly too long.
 
Top