Hi all,
is correct the lenght 7cm from fork at near the bolt of slave cylinder ?
the fork is perpendicular 90° respect the pin of slave cylinder.
the rubber of fork don't stay in the hole.
bad rubber with defect ?
wrong cylinder ( pin too much long ?)
collar inside the clutch is wrong ? more more height or low ?

the right lenght is not 7cm but 5.5 ~6cm ?
anyone have a picture of the clutch slave cylinder installaed in the Z ?

NEW KIT INSTALLED
PANTHER CLUTCH KIT NISSAN 240Z L24 S30 70-74 from UK performance and styling UK

new slave cylinder
( I have various new slave cylinder always identical)

https://www.youtube.com/watch?v=y6phjI38qMo

https://www.youtube.com/watch?v=xaj4I_325vA

https://www.youtube.com/watch?v=Ui6uu_4zzi8

 

your pin looks far too long!

 

Toopy thanks for info!

anyone have a picture of slave cylinder installed on a car ?
anyone have picture removed from a car ?
anyone have a picture of lenght of pin of slave c

 

Is the rod length adjustable like this one?

http://www.zcarsource.com/clutch-slave-cylinder-240z-70-72-new_8_56459_50600.html

 

Hi is not adjustable the rod

 

https://www.youtube.com/watch?v=y6phjI38qMo

Hi is not adjustable the rod

 

anyone have a link where buy the correct slave cylinder ?
( probably the slave cylinder on my z is for 280zx and not for 240z )