fuel

I am working on a 280z and one of the first things I wanted to do was remove the large bumpers and replace them with smaller 240z style bumpers. After removing the rear it became apparent that I would need to replace the rear weld-in panel as the 280z version has rather large holes in it. When I...

hi chaps, I have a set of three weber dcoM carbs and i don't like the bits that attach to the fuel inlet. Does anyone know a good retailer for weber unions and other bits and bobs? I've not been very clear here about what it is that i'm talking about so i'll add a picture in a bit. Cheers...

As the title suggests, I have a problem. When I first start up, it's fine. It goes through the revs ok and sounds fine. After a while, 5-10 mins perhaps ( but sometimes much longer), it starts to retard at around 3500-400RPM and won't rev any higher. After a while, the rev limit gets lower. Then...