Search results

Yes Rob

Remembered I have a pair of internal calipers - measured at 36mm internal.

Hi Sean, approximately 35mm - best endevours with a ruler.

I believe this to be a 'Mangoletsi' manifold based on previous posts/research - it has the casting number '4700' in the middle bracing. It is in very good clean condition. The carburettor-side ports measure 45mm diameter. £275 plus Royal Mail 48 postage cost based on package weight.

In good solid condition with surface rust only. The two outlet pipes have a diameter of approximately 48mm / 1.875". Ideally for use with cylinder heads which have round exhaust ports (N47 P79 P81) although this was successfully used on my 240Z square ported head. £80 collection from Solihull...

In good useble condition with front bearings included. £30 + postage.

Hi Sean, you can collect with the bumper on Wednesday. Cheers, Dave

Nice and clean, no dents but have a few surface scratches as can be seen in the photos. They fit the 240Z carbs perfectly and measure 70mm long and 68mm inside diameter at the end. Very light weight - presume they are made from aluminium ? £20 plus £2.88 Yodel postage.

Thanks for the info. I was not aware that this type of strut insert existed - thought they were all sealed on S30's. The 'tuning' aspect seems over complicated for the average owner - was it for a specialised application i.e. for competition use? I can't find anything in FSM's regarding setting...

Hi, I'm after some guidance on a strut cartridge please. The Nissan part number is 56210-E8126 and I've attached some photos. I could only find the attached reference table on this website www.jdmjunkies.ch. So it appears to be a firm/hard suspension cartridge for Europe but for use in...

Thanks Jon - I'll leave it to the professionals to remove any burrs. Yes Rob, they are a set of Nissan 0.5mm over bore pistons and con-rods. Bought them along time ago now - I'm having a clearout at the moment and may let them go so wanted to make sure they can be sold as a complete set.

Hi all, I have a set of replacement L24 pistons/con-rod assemblies but noticed that one of them has got several indentation/impact marks restricted to a small area between piston top and between the ring grooves - see photo. No idea how this happened - probably was there when I bought them some...

Excellent thank you all for the quick responses. I have a US car so that explains it. I'll discard it.

Can someone please explain what the parts high-lighted in yellow do. The S30 parts illustrations I have (attached) dont show these extra parts. Please post any illustrations if you have one. Thanks in advance.

Further items added on Ebay including a very nice pair of used UK Spec front bumper indicator lamp assemblies and engine inspection lamp. Just follow the same link above. Thanks for your interest.

Yes they're the ones. I can't find anything on Google so I guessed none were available. I was thinking of forming a thicker gasket mating surface by adding material around the internal surface of the housing and then cutting a new gasket out of rubber sheet. I'll have to give it some more thought.

Are there any suppliers of reproduction seal gaskets?

I have numerous items currently on Ebay for 240Z/260Z/280Z - please follow link the below if you are interested...

Yes defo is R180. I decided to proceed and fit the companion flange and fully torqued the pinion nut as specified in the manual this morning. I then removed both and the oil seal appears to be a tight fit now - I certainly can't pull it out using my fingers and I dont want to use an oil seal...

I purchased a new SKF 13978 oil seal from Rockauto but when I fitted it today it literally just slid in without giving much resistance at all. Now the manual says to use an oil seal drift so there should be some resistance when installing it obviusly to ensure that there is a good seal so I'm a...