Recent content by DJacey

Yes Rob

Remembered I have a pair of internal calipers - measured at 36mm internal.

Hi Sean, approximately 35mm - best endevours with a ruler.

I believe this to be a 'Mangoletsi' manifold based on previous posts/research - it has the casting number '4700' in the middle bracing. It is in very good clean condition. The carburettor-side ports measure 45mm diameter. £275 plus Royal Mail 48 postage cost based on package weight.

In good solid condition with surface rust only. The two outlet pipes have a diameter of approximately 48mm / 1.875". Ideally for use with cylinder heads which have round exhaust ports (N47 P79 P81) although this was successfully used on my 240Z square ported head. £80 collection from Solihull...

In good useble condition with front bearings included. £30 + postage.

Hi Sean, you can collect with the bumper on Wednesday. Cheers, Dave

Nice and clean, no dents but have a few surface scratches as can be seen in the photos. They fit the 240Z carbs perfectly and measure 70mm long and 68mm inside diameter at the end. Very light weight - presume they are made from aluminium ? £20 plus £2.88 Yodel postage.

Thanks for the info. I was not aware that this type of strut insert existed - thought they were all sealed on S30's. The 'tuning' aspect seems over complicated for the average owner - was it for a specialised application i.e. for competition use? I can't find anything in FSM's regarding setting...

Hi, I'm after some guidance on a strut cartridge please. The Nissan part number is 56210-E8126 and I've attached some photos. I could only find the attached reference table on this website www.jdmjunkies.ch. So it appears to be a firm/hard suspension cartridge for Europe but for use in...

Thanks Jon - I'll leave it to the professionals to remove any burrs. Yes Rob, they are a set of Nissan 0.5mm over bore pistons and con-rods. Bought them along time ago now - I'm having a clearout at the moment and may let them go so wanted to make sure they can be sold as a complete set.

Hi all, I have a set of replacement L24 pistons/con-rod assemblies but noticed that one of them has got several indentation/impact marks restricted to a small area between piston top and between the ring grooves - see photo. No idea how this happened - probably was there when I bought them some...

Excellent thank you all for the quick responses. I have a US car so that explains it. I'll discard it.

Can someone please explain what the parts high-lighted in yellow do. The S30 parts illustrations I have (attached) dont show these extra parts. Please post any illustrations if you have one. Thanks in advance.

Further items added on Ebay including a very nice pair of used UK Spec front bumper indicator lamp assemblies and engine inspection lamp. Just follow the same link above. Thanks for your interest.