richiep
Club Member
Not been very active on here recently but have done a few Z bits. Charged my FairladyZ ‘s battery this week! Ready for a return to the road in a week or two.
I’ve done a few bits on Project Dixie too. Just picked up this little lot from my blaster/powder coater (who also runs a TR resto business). Superb quality finish.
Even the U.K. spec anti-roll bar looks good; despite having been dumped outside my garage for the last four years or so!
Also got some rear marker light deletes from Skillard in the US:
Also started sizing up the replacement of the battery tray area...
I
Good job I bought a mig welder! My blaster is also a Hobbyweld stockist so also picked up a big gas cylinder today.
Current state of shell:
I’ve done a few bits on Project Dixie too. Just picked up this little lot from my blaster/powder coater (who also runs a TR resto business). Superb quality finish.
Even the U.K. spec anti-roll bar looks good; despite having been dumped outside my garage for the last four years or so!
Also got some rear marker light deletes from Skillard in the US:
Also started sizing up the replacement of the battery tray area...
I
Good job I bought a mig welder! My blaster is also a Hobbyweld stockist so also picked up a big gas cylinder today.
Current state of shell: