Hi
I was hoping someone more knowledgeable than I might be able to help point me in the right direction on this forum.
I'm looking for anyone who has documented their RHD conversion process. My apologies if it's somewhere obvious and I have just failed to find it but I have searched this forum and the internet in general and can't seem to find what I'm looking for.
I can find that people have asked the same question in other places on the internet, unfortunately I can't find any real answers as the rest of the thread usually degenerates into arguing about why you would convert a LHD car.
To be clear, I'm not concerned with maintaining the authenticity of an LHD car (which seems to be the general cause of most of the arguing), I want to use the car as a daily drive so would really like to convert to RHD.
From the little information I can find, there seems to be two ways of doing this. One is to swap a RHD bulkhead panel into an LHD shell, the other is to modify the existing bulkhead.
I wondered if anyone on this forum knew where I could find a thread which had information on each option?
Thanks
I was hoping someone more knowledgeable than I might be able to help point me in the right direction on this forum.
I'm looking for anyone who has documented their RHD conversion process. My apologies if it's somewhere obvious and I have just failed to find it but I have searched this forum and the internet in general and can't seem to find what I'm looking for.
I can find that people have asked the same question in other places on the internet, unfortunately I can't find any real answers as the rest of the thread usually degenerates into arguing about why you would convert a LHD car.
To be clear, I'm not concerned with maintaining the authenticity of an LHD car (which seems to be the general cause of most of the arguing), I want to use the car as a daily drive so would really like to convert to RHD.
From the little information I can find, there seems to be two ways of doing this. One is to swap a RHD bulkhead panel into an LHD shell, the other is to modify the existing bulkhead.
I wondered if anyone on this forum knew where I could find a thread which had information on each option?
Thanks